Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Problem With Switch 4500

Yestarday I tried to change the power supply of a Cisco 4500, it had Power Supply 1400 Ac, and I tried to change it to 6000 ac dual input. But when I made the transition, the supervisor Engine failed to satart. the Status led was on red, so the switch could not start. Does someone knows the posible reason for this?

9 REPLIES
Hall of Fame Super Blue

Re: Problem With Switch 4500

Which supervisor are you running ?

Jon

New Member

Re: Problem With Switch 4500

Supervisor Engine V

Hall of Fame Super Blue

Re: Problem With Switch 4500

Omar

Sorry, what chassis do you have ie. the 4500 or the 4500-E ?

Jon

New Member

Re: Problem With Switch 4500

4500-E

Hall of Fame Super Blue

Re: Problem With Switch 4500

Final question - which IOS version ?

Jon

New Member

Re: Problem With Switch 4500

Acutally I don't have the versión, I'm traying to obtain that info, we didn't have access to the console. We were just responsable to put the Power Supply on the chasis, do you think is a Version Problem?

Hall of Fame Super Blue

Re: Problem With Switch 4500

Omar

do you think is a Version Problem?

Could be. You need a minimum of 12.2(52)SG to run this power supply, see table 9 in the attached doc -

4500 power supplies

Jon

New Member

Re: Problem With Switch 4500

Thank You I will have the verision and if it is not the version we will update the switch...

New Member

Re: Problem With Switch 4500

Jon,

Thank you for your help.

The problem was the IOS Version on the Switch, we already solved the problem.

Thanks

397
Views
0
Helpful
9
Replies
CreatePlease to create content