Problems after performing factory default-reset on 877
I require some assistance with my 877 router.
I recently performed a factory reset by pressing the rest button within 5 seconds of boot. Since then I can get no connection to the router at all. None of the interfaces appear to be active so cannot connect via ethernet. I attached the console cable, booted the router and nothing appears on the screen in hyper terminal regardless of the terminal settings I use. I have tried several PC's and several console cables to rule them out. I have also tried to the CTRL+BREAK to try to get into ROMMON without success. The OK light is on and the CD light flashes.
Does anyone have any ideas about what else I can try?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...