The 10GE SPA interface cards have two LEDs, one for status and the other for link. Both are illuminated, but there is no fiber connected to the cards and I cannot figure out if the whole ASR is bad, or just the cards. Also, the ASR's "boot" LED is constantly blinking, so I'm thinking *something* is messed up with this boat anchor. Any ideas on what to test or look for?
Out of curiosity, is there any way to session into the ESP-10 that's installed like you would with a line card on a 6500? I didn't see anything indicating you actually move from card to card like that with the ASR series.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.