Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Problems with getting packet capture to work with IPv6

I am trying to do a packet capture on a IPv6 router connected to a Tunnel Broker -

ipv6 access-list ipv6_capture

permit ipv6 any host 2001:470:1F11:102:5AB0:35FF:FE88:D4C6

permit ipv6 host 2001:470:1F11:102:5AB0:35FF:FE88:D4C6 any

monitor capture buffer ipv6_buffer

monitor capture buffer ipv6_buffer filter access-list ipv6_capture

monitor capture point ipv6 cef ipv6_point Tunnel 0 both

monitor capture point associate ipv6_point ipv6_buffer

monitor capture point start ipv6_point

I can look in the capture buffer but when I try to export the capture buffer, I get a export of buffer failed error.

Has anyone been able to get this sequence of commands to work ?

This has worked in IPv6, so I have adapted the commands for IPv6.

Thanks,

Ron

176
Views
0
Helpful
0
Replies
CreatePlease to create content