I'm trying to setup a secure network for hosting a webapplication. I'm using 2 cisco 1841 routers for setting up a DMZ.
I have succesfully created a NAT from the WebServer (192.168.1.2) to the Internet (188.8.131.52) and a NAT from AdministratorPC (192.168.10.2, VLAN 10) to the internet, using NAT overloading.
For the above to work, I've set interface fa0/0 on DMZRouter (the one to the internet, 184.108.40.206/24) to 'nat outside'.
Interface fa0/1 on DMZRouter (to the webserver, 192.168.1.0/29) and interface s0/0/0 on DMZRouter (to OfficeRouter) are set to 'nat inside'.
What I'm missing now is a NAT from DatabaseServer to the 192.168.1.0/29 network. But to create this NAT we must set interface fa0/1 on DMZRouter (to the WebServer, 192.168.1.0/29) to 'nat outside', but that is not possible because it should also be 'nat inside' (for the above NATs to work).
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...