Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Protected port BUT allow specific MAC

Hi all,

i have big problem.

We are using catalyst 2960S Lan Base IOS on Radio towers. We just bought 50 Accest points, thas are GPS synchronized. Problem is the APs need to be connected on L2-mac betwen each other. But at this time we are using port isolation on each switch (tower) by protected port function to isolate clients from each other.

My question is, is possible to specifi a Mac addresses in specific vlan thats can comunicate betwen protected ports? On tower is one Master unit and others are slave. I thing there is only 1 dirrection comunication - from master to slave.

Can anyone help me please?

BR

Dave

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Protected port BUT allow specific MAC

Hi David,

Looks like you can use Vlan access map filtering at the mac level for this...

Regards,

Wendell..

2 REPLIES
New Member

Protected port BUT allow specific MAC

Hi David,

Looks like you can use Vlan access map filtering at the mac level for this...

Regards,

Wendell..

New Member

Protected port BUT allow specific MAC

If i specify it by mac, will it alow L3 IP layer too from current MAC address?

Does IP Base on 2960 supports this feature?

Thanx

BR


Dave

457
Views
0
Helpful
2
Replies
CreatePlease login to create content