Hi All,
I'm trying to configure the PTP on the ASR9001 and I'd like to use the transport mode ETHERNET instead of IPv4.
From the RP/0/RSP0/CPU0:ASR9001-2#show ptp interfaces it look likes that the Ethernet capability is not supported:
TenGigE0/0/1/1 is in Master state
PTP port number: 1
IPv4 transport: IPv4 address 10.85.52.5
Linestate: Up
Mechanism: Two-step delay-request-response
Sync rate: every second
Announce rate: every 2 seconds, timeout 3 intervals
Min Delay-Request rate: every second
CoS: General 6, Event 6, DSCP: General 46, Event 46
Platform capabilities:
Supported: One-step, Two-step, IPv4, Unicast, Master, Slave
Not-supported: Ethernet, Multicast, IPv6, Source IP
Max-Sync-rate: 128 per second
Master state only
0 Unicast peers
Can you please support me?
thanks in advance.
BR// Saverio
