Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Public IP's assignment - DHCP problem within VLAN

Hi everyone


I'm facing a problem i cannot solve with a SG300-20. Hope someone have a hint.

What i try to do is, to create a VLAN for allocating Public IP's from the ISP.


The infrastructure is as followed. Got a cable modem with one ethernet port from the provider. That is connected to the SG300 port 1.

Then i got a firewall with two ethernet WAN ports. Those are connected to the SG300 on port 2 and 3.

Port 1-3 are access ports with the VID2.

The SG300 is in layer 3 mode.


The WAN 1 of the firewall get an dyn IP but the WAN 2 not, because the ISP assigns the IPs out of different subnets.

New Member

Someone please?

Someone please?


I also checked it out when i switched to layer 2 mode.

Also tried to add dhcp relay to the dhcp server of the provider.

Notihing works.