Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

PWR-C45-4200ACV -error disa but no alarm?

Hi.

I had several times the issue, that one PS of the C45-4200 type was in the following state:

PS2 PWR-C45-4200ACV AC 4200W err-disable good good

The problem is, that no SNMP trap was generated and so nothing was noticed unless someone used the show power command.

After reset the PS, a big bang occurs normally and then, of course, you have all the alarms you want...

Is this a design problem or how can one ensure PS redundancy?

Thanks and regards

Danny

801
Views
0
Helpful
0
Replies
CreatePlease to create content