Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Q about SPAN destination port number limitations.

According to some 2950 config guide there is a limitation that only 1 (one) destination port for SPAN session can exist. This limitation does not included in every config guide for 2950. But in "Configuring guideline" section always referred

~~~~~~~~~~~~~~

monitor session session_number destination interface interface-id [encapsulation {dot1q}]

~~~~~~~~~~~~~~

On the other hand, that is in 2960 config guide:

~~~~~~~~~~~~~~

monitor session session_number destination {interface interface-id [, | -] [encapsulation {dot1q | replicate}]}

~~~~~~~~~~~~~~

Draw attention to comma and dash. So can I suggest, that 2960 it the lowest catalyst model, supported multiple destination ports for one SPAN session?

Thanks!

2 REPLIES
Silver

Re: Q about SPAN destination port number limitations.

New Member

Re: Q about SPAN destination port number limitations.

Thanks, but I have not found answer for my question in that doc...

579
Views
0
Helpful
2
Replies
CreatePlease to create content