Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

QinQ at the PE

hi.

i have 2 sites connect througt VPLS, the VPLS provider does not support QinQ, but said that they have space for the QinQ tag.

i have 2 C3750X switchen 1 at each site.

if the VPLS Provider gives me an access port, should i then be able to issue the commands below, on the 2 C3750 on the interfaces facing the provider.

int gi 1/0/1

** interface facing the VPLS provider **

switchport access vlan 104

switchport mode dot1q-tunnel

l2protocol-tunnel cdp

l2protocol-tunnel stp

l2protocol-tunnel vtp

or have i misunderstod how this works ?

Everyone's tags (2)
205
Views
0
Helpful
0
Replies