I'm trying to setting up a Lab and i have an issue with Cisco Q in Q through an Hp ProCurve.
If i only connect an HP 2520 between the Switch B and C, it's working fine, PC1 can ping PC2 through vlan 400. But if i replace the 2520 by a e2620 with the same config, PC1 can't ping the other. The only working thing is if i do a SHOW CDP NEIGHBOR on Switch B, i can see the Switch C at the other side of the tunnel. Vlan 400 and vlan 401 doesnt work.
I would like to know why it's not working with the HP e2620. I can't see where the problem is.
*!*!*!* See the attached file *!*!*!* Hope the file will help you to understand the setup.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.