Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

QOS between two cat4506s

Hello,

Question I have two cat4506s connected via an etherchannel. Do I need to enable "qos trust dscp" on the etherchannel interface to get markings from one switch to another? Since it is a trunk shouldnt it already accept the QOS tages and not wipe them?

2 REPLIES

Re: QOS between two cat4506s

You do not need to configure qos trust dscp on trunks. They will accept the tags and not re-write/remove them.

Re: QOS between two cat4506s

After you configure the access port queuing, you must also configure the uplink interfaces to the distribution, or core, switch. This involves enabling trust for Ethernet frames coming into the trunk port, enabling output scheduling, and manipulating the CoS-to-queue mapping entrance criteria, mapping the CoS values to the appropriate DSCP value

http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps708/prod_white_paper0900aecd80233956.html

rate if helpful

141
Views
0
Helpful
2
Replies
CreatePlease login to create content