Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

QoS configuration for Polycom Phones

Hello,

I would like to know if there an specific configuration in order to apply QoS configuration in Switches 3750X for Polycoms Phones.

I was reviewing the information from Cisco but mostly of them apply only for cisco phones, and just some or basic for non cisco phones.

Thanks for the advice.

Regards,

Everyone's tags (4)
1 REPLY
Silver

QoS configuration for Polycom Phones

I don't think there is any specific config based on the vendor.

The only requirment is- your phones should be able to mark the packets, following are the cisco recommended markings for VOIP- L2 audio- 5, L2 signaling- 3  and L3 audio- 46, L3 signaling- 26.

If they can't mark the packets you can use MQC and match the packets based on ip address ranges ( access-list)

Check the below links they explain about the QoS for 3750 switches

http://www.cisco.com/en/US/products/hw/switches/ps5023/products_tech_note09186a0080883f9e.shtml

http://www.youtube.com/watch?v=IA4iOrn2eiU

Siddhartha
2385
Views
0
Helpful
1
Replies