I will be involved in a QoS project and wanted to get some guidance on where to look for information to prep for this project. Also, I wanted to find out if configuring QoS would be a complex assignment and should perhaps take a training course!
QoS can be difficult but it depends on your experience in the past with traffic-shaping and how complex your network is as to whether a training course is needed. One tip I suggest is that you make sure you know EXACTLY how the network is laid out and setup a proper VLAN(s) to seperate voice and data. Also understand what devices require QoS and what classification they support (CoS, DSCP, etc).
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...