Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

QoS in 6500 supervisor 2t & 4500X ver 15

Hi

I hav todat the following config for ex, int 3560 switchar and 3750

Global:

mls qos

At the interface:

switcport mod access

auto qos voip trust

mls qos trust dsco

and also on other interface:

switchport mode trunk

mls qos trust dscp

auto qos voip trust

What commands should i use in 6500  sup.2T och 4500x with ver 15

too ge t same function?

it is not support with mls in these products

4 REPLIES
VIP Super Bronze

QoS in 6500 supervisor 2t & 4500X ver 15

That is correct.  There is no more "mls qos" command with PFC-4 (Sup 2T).

try:

show auto qos default

and have a look at this document for all changes in Sup-2T qos architecture.

Also see table-8:

http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps708/white_paper_c11-652042.html

HTH

New Member

QoS in 6500 supervisor 2t & 4500X ver 15

Hi

Thank you för the answer

So you mean that i shall use the command

auto qos default

as a global command?

Does i need some command under the interface?

does the queueing  work?

I dont think that i can use trust dscp then the interface is a switchport, only then the port is a route port

but will it work all the same?

SP

VIP Super Bronze

QoS in 6500 supervisor 2t & 4500X ver 15

Hi,

With Sup-2T, the interfaces by default trust DSCP.

do a "show queueing interface gix/xx and look for

Trust state: trust DSCP

Trust state in queueing: trust COS

HTH

New Member

QoS in 6500 supervisor 2t & 4500X ver 15

Hi

What commands should i use in 4500x switches?

You cant use the command

show queueing interface gix/xx

Then it by  default trust DSCP,

Does i need to config a policymap under the interface?

What queue will it use if ?

sp

1065
Views
0
Helpful
4
Replies