Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

qos on a layer2 only subnet

I have a layer2 only vlan across different floors on a number of 6500s running IOS, is there a simple way to mark the traffic on that vlan efficiently instead of marking on hundred of ports manually ? Thanks for the input.

1 REPLY
Super Bronze

Re: qos on a layer2 only subnet

Unsure, what all the 6500 supports, but for L2 only, you might be able to mark on just L2 uplinks. Or, if you are also running L3, mark at the (virtual) gateway interface.

126
Views
0
Helpful
1
Replies