Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bronze

QoS on a non trunk Interface

Hi,

I am new to QoS and would like to setup auto QoS between my site and another site. Below is what I intend to implement on my switch (Cisco 6506-e) SUP720. Is this good enough?

switch(config)#mls qos

switch(config)#mls qos map cos-dscp 0 8 16 24 32 46 48 54

!

switch(config-if)#ip address x.x.x.x/30

switch(config-if)#mls qos trust cos

!

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: QoS on a non trunk Interface

Hi,

One suggestion for change:

Instead of mls qos trust cos, do mls qos trust dscp

As CoS is only sent in 802.1q header (i.e. a trunked interface), it won't work. Trusting DSCP will work perfectly for L3 interfaces.

Other than that, what you have there is fine for a basic config.

2 REPLIES
Bronze

Re: QoS on a non trunk Interface

Hi,

One suggestion for change:

Instead of mls qos trust cos, do mls qos trust dscp

As CoS is only sent in 802.1q header (i.e. a trunked interface), it won't work. Trusting DSCP will work perfectly for L3 interfaces.

Other than that, what you have there is fine for a basic config.

Bronze

Re: QoS on a non trunk Interface

thanks much for the quick reply.

124
Views
0
Helpful
2
Replies