Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

QoS on Catalyst 6500

Hi,

If I enable QoS on a Catalyst 6500, which DSCP value and which CoS wil be assigned to routing protocols and other control protocols when those packet arrive on a switch egress port ? In another words, is there any default queuing and prioritization for control traffic ?

Thank you

Yves

1 REPLY
Bronze

Re: QoS on Catalyst 6500

hi

you are a CCIE am not but i will try to give my point of view :)

packet dealing with system-use always have an ip precedence or a class of service cos of 6 and 7 (those are reserved for that purpose and it not recommanded as stated by cisco to use them for other packets)

translate form ip precedence to dscp to get the adequate value in dscp, about prioritization and queing, i thinks when u have a bandwidth the system only gives you 75 percent of the available bandwidth the other amount 25 is reserved for system use including control and routing protocol, u can manipulate reserved value by using max-reserved bandwitdh...

HTP

welcome to any feedback

165
Views
0
Helpful
1
Replies