Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

QoS on Catalyst not runnning,advise pls!

Hi,

I did a ftp test.Speed i got is 25KB/S.it seems like the policy is not taking effect.Any idea?Together is the config.

class-map match-all abc

match access-group 1

!

!

policy-map vlan

class abc

police 1000000 65536 exceed-action drop

!

ip subnet-zero

no ip finger

!

!

!

interface FastEthernet0/1

switchport mode trunk

!

interface FastEthernet0/2

service-policy input vlan

access-list 1 permit any

1 REPLY
Cisco Employee

Re: QoS on Catalyst not runnning,advise pls!

Hello,

Please go over all the following questions:

What is the type of your switch and the IOS version you are running? Is the "mls qos" command present in the configuration? Is the policy-map applied in the correct direction?

Also note that this policing limits the traffic down to 1 Mbps. You have said that the FTP speed was 25 KBytes/s. That is well under the limit that the policer imposes. Is there something wrong with it?

Best regards,

Peter

104
Views
0
Helpful
1
Replies