I am trying to configure QoS on the 2950 switch with IOS version c2950-i6q4l2-tar.121-22.EA10a. I do not have the mls qos, class-map, policy map and other qos comand available. The configuration guide says I should be able to turn on Auto QoS for ths switch model, but that command is not available.
The only commands that I can issue are the interface command mls qos trust, and the global wrr-queue cos-map commands
I am trying to turn on QoS, set TOS = 184 and DSCP=46 for a traffic class.
How can I do this when I am unble to classify or mark the traffic?
All the commands that you are talking about are available on the EMI version switch. Could you please let me know what is the part # for the 2950 that you have . Most likely what you have is an SMI version , which has only a subset of qos commands available.
They all run the same image but it is smart enough to know what switch it is and will only enable the features for that particular switch. I believe if you do a show version it will tell you if it is an SMI or an EMI switch in the description field. There is no way to upgrade that if it is a SMI switch.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...