Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

QoS on Vlan Interfaces

I have a 3845 router installed at each of two sites and I have installed a hwic-4esw card in each router. One of the 10/100 Ethernet ports on the hwic-4esw connects to one of two isp routers. The

isp's routers include an E3 interface (34 Mbps) for a dedicated link between the two sites.

I could only get this port to act as a switchport (no switchport cmd wouldn't take, said it wasn't the right hardware) so I set up a vlan interface with an IP address and assigned it to one of the

hwic-4esw ports to allow routing on the port. I now want to enable QoS over the link to prioritize the production traffic but when I tried, I get an error message that I can't use queing parameters on a vlan interface (see attached for the screen-dump of the SDM message).

Is there a way to get this to work on an hwic-4esw port? If not, what type of interface would be the best choice for a 100base-tx interface to the isp routers? -I have both HWIC and NME slots available.

Thanks.

1 REPLY
New Member

Re: QoS on Vlan Interfaces

The HWIC-4ESW appears very limited in its QoS support.

Have you tried using either of the two built in gig copper ports?

If you're short of ports, the HWIC-1FE or HWIC-2FE might do.

QoS capabilities vary by IOS. What version are you running on the 3845?

135
Views
0
Helpful
1
Replies