04-30-2012 04:41 AM - edited 03-07-2019 06:24 AM
Hi,
We will deploy a wireless based network for our new plant soon.
most of the users will use wirless instand of wire cable except servers.
all the phones will use wireless also (Cisco cius)
Here is my question.
How can we setup QoS on wireless enviroument?
Baed on a tech note comes from Cisco:
mls qos turst dscp - on the switchport which connecto to AP.
but how about the switch port connect to WLC?
how can we allow high priority traffic send out first, I mean from wireless user side.
(over 20 users per AP, how can I allow phone send out first)
many thanks and have a nice day.
05-01-2012 03:38 AM
Hi
for the switchport connected to the controllers i ve read that
mls qos trust cos
is recommended.
i already started to write but this article explaines it better than i can :-)
http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a00807e9717.shtml
05-01-2012 03:41 AM
.
05-01-2012 03:57 AM
Hi, Ton V
I read this article. one thing confused me.
Looks it seperate vlans by priorty traffic, but we usually put all the wireless client in a big vlan domain.
we have a QoS policy-map in our network end-to-end. so all the traffic into wlc should be marked already.
The big thing is how can we mark the traffic from AP to WLC? and allow AP accept high Q from wireless cilnet first instand of bulk traffic?
Thanks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide