Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

QOS only matching on Precedence 6 and 7

Hi,

I have this issue on Cisco 7206VXR whereby the configured class maps only match on IP predence 6 and 7. I have configured seven class maps to match on each of the seven IP Precedence values. The Ip precedence is being set upstream by an avaya phone from precedence 1 to 7 and I have confirmed, by sniffers, that the right precedence is being set on packets.

I have configured the interface where the policy is applied outbound with the following command:

interface POS2/0

mtu 1600

ip address X.X.X.X X.X.X.X

load-interval 30

crypto map XXXXX

max-reserved-bandwidth 100

service-policy output XXX

Router model Cisco 7206VXR (NPE-G2)

Software:c7200p-advipservicesk9-mz.124-15.T1.bin

I removed and reapplied the config, but there is still only a match only on precedence 6 and seven.

2 REPLIES

Re: QOS only matching on Precedence 6 and 7

What traffic is getting encrypted by the crypto map, does it include the traffic matching the class-maps?

You might need to look at Qos-preclassify

http://www.cisco.com/en/US/products/ps6635/products_white_paper09186a00801890f7.shtml

Posting your QOS configurations can help in investigating further

HTH

Narayan

HTH

Narayan

Re: QOS only matching on Precedence 6 and 7

Precedence 6 & 7 are reserved values & not meant to be used for user traffic. If you are talking about avaya phones then, they mark voice traffic with Prec 5 & signalling traffic with Prec 3.

461
Views
0
Helpful
2
Replies
CreatePlease to create content