QOS, priority between "Switchport priority..." and auto qos.
What would happen if you have an interface with both Switchport priority extend cos "value", and then an AUTO QOS VOIP TRUST. Since they are conflicting, I assume the manual extend cos "value" would be used? (For a PC attached to the phone)
Re: QOS, priority between "Switchport priority..." and auto qos.
AUTO QOS VOIP TRUST is used for IP Phones only it doesnot trust the PC COS. You have to manually configure the "Switchport priority extend cos "value" command to override the COS vlaue sent by the PC. It is recommended to have that command, auto QoS doesn't enable that. So if you normally do use that command, it is recommended to have it with auto QoS also.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...