what we have here it's a WS-C3560-24PS and what I can not figure out is what exactly means the last line of the above output -
Policer: Inprofile: 20891 OutofProfile: 364 ???
What means Inprofile and OutofProfile?
OutofProfile: Dropped Packets as an exceeding action of the policy or packets which not match any access-list?
I'm afraid that the servicepolicy does not work as expected. If I try a videocall there are video buckings. If I rise the burst size everything is okay, but what I expect it is a bandwidth for the videocall which is lower than the existing configured bandwidth and burst size.
I'll appreciate any help or any hint if some of you wants to help us...
sh mls qos interface g0/3 statistics
GigabitEthernet0/3 (All statistics are in packets)
OK, so you have two policies (I assume the test policy is not permanent?). I also assume the class 'video' in the 'mark-traffic' policy is where you are having issues? You are attempting to police this class at 1Mbps and you are seeing drops?
The burst size is the depth of the token bucket in bytes (as opposed to the rate that is configured as bits-per-second).
What to configure the burst size to be seems to be an area of confusion and to be honest it confuses me.. Burst size on routers was always configured using the formula Bc = [(CIR / 8) * 1.5], but this is not relevant for calculating the burst size on the 3560 and how you calculate it depends...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.