Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

QOS Question

Will this work... Policing the interface and then applying a Service policy on the interface? I though to do that you would have to so Child/Parent  MQC design?

 

interface FastEthernet0/1
 bandwidth 5000
 no ip address
 ip flow ingress
 speed 100
 full-duplex
 traffic-shape rate 5000000 125000 125000 1000
 max-reserved-bandwidth 100
 service-policy output qospolicy

1 REPLY
Super Bronze

sclaimerThe Author of this

sclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting

It might, but if it does, I'm unsure of the order of operations.

If I needed to shape, I wouldn't mix an explicit traffic shaper with a service policy, I would do the shaping within MQC.

PS:

BTW, traffic-shape doesn't police.

39
Views
0
Helpful
1
Replies
CreatePlease to create content