Hi, I would like to know if it is possible to specify a virtual interface speed on a gig interface to apply QOS shaping. I have a 4500 port connected at 100 Mbps to a WAN provider device with a 40 Mbps WAN connection. I would like to specify percent shaping for 4 traffic class but i not sure if the shaping will apply for 40 Mbps because my interface is connected at 100 Mbps. Thanks, David
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...