Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

qos tagging and dot1q trunking

Aloha All,

I did some research and found some possible partial answers but not a complete answer to the following question.  If you have a router with multiple direct vanilla FE (non trunked) interfaces on a switch trying to send QOS tagged packets to a wifi bridge several switches away does the trunking in the switched infrastructure mess with the qos tags if no qos is configured on the switches.

Does anyone know this?  Does it depend on the switch?  We have new 2960's running 12.2 and a few older 2950's running 12.1

Mahalo!

1 REPLY
Super Bronze

qos tagging and dot1q trunking

Disclaimer

The    Author of this posting offers the information contained within this    posting without consideration and with the reader's understanding that    there's no implied or expressed suitability or fitness for any  purpose.   Information provided is for informational purposes only and  should not   be construed as rendering professional advice of any kind.  Usage of  this  posting's information is solely at reader's own risk.

Liability Disclaimer

In    no event shall Author be liable for any damages whatsoever  (including,   without limitation, damages for loss of use, data or  profit) arising  out  of the use or inability to use the posting's  information even if  Author  has been advised of the possibility of such  damage.

Posting

Generally, if a Cisco switch's QoS is disabled, packet's ToS is passed as is.  If QoS is enabled, by default, switch will reset ToS to zero.

223
Views
0
Helpful
1
Replies
CreatePlease to create content