08-28-2009 12:43 PM - edited 03-06-2019 07:29 AM
Is there a command to verify the QOS markings and trust settings on a 6500? I am trying to verify if packets are being marked based on the trust settings. There is no external sniffer. Thanks
08-28-2009 12:47 PM
You can capture this information with Netflow enabled globally in the switch and on the interfaces, then with the command show mls ip detail
Router# show mls ip detail
IP Destination IP Source Vlan Xtag L3-protocol Encapsulation
--------------+---------------+----+----+-----------+-------------+
RW-Vlan RW-MACSource RW-MACDestination Bytes Packets Age
-------+--------------+-----------------+-----------+-----------+-----+
Last Seen QoS Police Count Threshold Leak Drop Bucket
---------+-----------+------------+---------+-----------+----+-------+
Use-Tbl Use-Enble
+------+---------+
The TOS information will be shown in the output.
HTH,
__
Edison.
08-30-2009 07:54 AM
Try this command "show mls qos ip" this will show policy-map/class-map attached and set/trust hits on each class-map. You can also just view an individual interface by using "show mls qos ip interface"
ex. show mls qos ip vlan 50
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: