Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Qos Verification on 6500

Is there a command to verify the QOS markings and trust settings on a 6500? I am trying to verify if packets are being marked based on the trust settings. There is no external sniffer. Thanks

2 REPLIES
Hall of Fame Super Bronze

Re: Qos Verification on 6500

You can capture this information with Netflow enabled globally in the switch and on the interfaces, then with the command show mls ip detail

Router# show mls ip detail

IP Destination IP Source Vlan Xtag L3-protocol Encapsulation

--------------+---------------+----+----+-----------+-------------+

RW-Vlan RW-MACSource RW-MACDestination Bytes Packets Age

-------+--------------+-----------------+-----------+-----------+-----+

Last Seen QoS Police Count Threshold Leak Drop Bucket

---------+-----------+------------+---------+-----------+----+-------+

Use-Tbl Use-Enble

+------+---------+

The TOS information will be shown in the output.

HTH,

__

Edison.

New Member

Re: Qos Verification on 6500

Try this command "show mls qos ip" this will show policy-map/class-map attached and set/trust hits on each class-map. You can also just view an individual interface by using "show mls qos ip interface"

ex. show mls qos ip vlan 50

291
Views
0
Helpful
2
Replies
CreatePlease login to create content