1> VPC peer-link is made up of 2 dedicated 10g links. Can I have a peer-link , where link 1 is on one type of line card ( say N7K-M132XP-12L ) AND link 2 is on another type of line card ( say N7K-M108X2-12L ). would that work ?
2> Sounds like a basic ospf question. I am a bit confused to design an ospf network where the same subnet is kept in area 5 on 1 router and in area 6 on a different router. These two routers acting as ABR will advertise these subnets into area 0.
Would there be any problem if i keep the area 5 and 6 side of interfaces as passive interfaces?
Any detailed response with the fundamental reason for any probable problem would be highly appreciated.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.