Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Question about BGP routing tshooting.

Hello there,

Have a problem at job and couldnt understant what is going on with routing between vrfs.

Just a quick question.

From base perspective: How could it be, if I can ping ip address using specified source - and it's successful. So we can assume that there is connectivity between them. But i cant understood why the ping in reverse is failing... Both points (for this example loopbacks) are ping enabled.

for ilustration:  Domain (A): ping X with source Z = successfull

        Domain (B) reverese:ping Z with source X = unsuccesfull                 it the ping from one side is successful (replies can make way to come back we should asume all is ok, but...)

3 REPLIES
VIP Super Bronze

Question about BGP routing tshooting.

are you sourcing each ping from the right VRF?

can you post your config from both routers?

what type of devices are you using and what is the design look like?

New Member

Question about BGP routing tshooting.

hey man, sorry i cant, cause it's complex ISP network, but i can assure that there is no filters blocking icmps... and yes im sourcing right. Actualy this is not Cisco devices, but it's very simmilar  - Juniper ERXs. I just need some hints where i can continue troubleshooting

VIP Super Bronze

Re: Question about BGP routing tshooting.

Have you configured the same RT on both routers. 

sample config:

instance-type vrf;

interface fe-0/0/2.0;

route-distinguisher 10.0.3.3:1;

vrf-target target:65412:100;

HTH

272
Views
3
Helpful
3
Replies