Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

question about multilinking isdn's

Hi all, When multilinking say 4 x isdn bri's, when I create the dialler interface to dial them all, on each bri, can I use no ip address, so it will use the ip of my dialler ?

1 REPLY
New Member

Re: question about multilinking isdn's

hi,

Yes, IP address is used only on Dialler interface only, not on BRI in dialler-group.

regards

romek

110
Views
0
Helpful
1
Replies
CreatePlease to create content