Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Question about port security 2

I do some practice with switchport security.I activated sticky security on swich ports and did
violation-shutdown. The problem is now that i can not find how to acitvate them again without
reseting my switch. The command "no shutdown" in interface for, lets say, fa0/1 just simple do
nothing.  After violation i tried to do: "interface fa0/1 shut" and then "no shut" - it tries
to activate but after couple of seconds it shows violation again. How to switch off the
"violation" ?

Many thanks

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Question about port security 2

Is the port learning a new MAC on the interface? Post your interface config please.

2 REPLIES

Re: Question about port security 2

Is the port learning a new MAC on the interface? Post your interface config please.

New Member

Re: Question about port security 2

I just learned: " no switchport port-security"

and then

"int fa0/1 no shut".

Thank you for your quick respond.

323
Views
0
Helpful
2
Replies