Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Question about RPS2300 and 'redundancy" config on IOS router

We have a 2951 router connected to an RPS2300 remote power supply.  On the router there are two commands applied in global config mode, "redundancy inter-device" and "redundancy".  The engineer who set up the router originally states that these commands are necessary for the RPS2300 to work properly with the 2951, but the documentation for the "redundancy inter-device" and "redundancy" commands do not seem to be related to the RPS at all.  Can anyone tell me if either of these commands are required for RPS, or if there is any other config that must be added to the 2951 for the RPS2300 to function properly?

 

An excerpt from the 2951 config:

-----------------------------------------------------------------------------------

vtp mode transparent
username <detail removed>

username <detail removed>
!
redundancy inter-device
!
!
redundancy
!
!
controller T1 0/0/0

-----------------------------------------------------------------------------------

As you can see, there is no additional configuration under either of the "redundancy" commands.
 

 

Thanks

-Mat

 

1 REPLY
New Member

To clarify, the 2951 router

To clarify, the 2951 router has an RPS-ADPTR-2921-51 module installed which connects to the RPS2300 unit.

 

 

-Mat

 

30
Views
0
Helpful
1
Replies