Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bronze

Question about the lithium battery on MSFC

Hi everyone,

I have the question about the lithium battery on MSFC.

Is there any command to display voltage of lithium battery to confirm whether the life of lithium battery is lost.

I can not find related information on CCO.

Your information would be appreciated.

Regards,

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Question about the lithium battery on MSFC

To monitor the voltage or health of the battery, I have not seen any CLI command that displays information on the battery status.

There is a simple battery check built into the NVRAM component. When there is a drop in the battery voltage, the NVRAM generates a 'battery low' signal. This is used to notify SW of this condition. SW then generates the 'NVRAM low battery' error message. Since the battery is entirely enclosed within the NVRAM component, there is no other way to monitor battery health in a more direct manner.

2 REPLIES
Silver

Re: Question about the lithium battery on MSFC

To monitor the voltage or health of the battery, I have not seen any CLI command that displays information on the battery status.

There is a simple battery check built into the NVRAM component. When there is a drop in the battery voltage, the NVRAM generates a 'battery low' signal. This is used to notify SW of this condition. SW then generates the 'NVRAM low battery' error message. Since the battery is entirely enclosed within the NVRAM component, there is no other way to monitor battery health in a more direct manner.

Bronze

Re: Question about the lithium battery on MSFC

Thank you very much for your reply.

I understand it.

Regards,

193
Views
0
Helpful
2
Replies
CreatePlease login to create content