Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Question of Cat6513 upgrade

Last week we upgraded Image of Cat6513 from 12.2(18)SXF3 to the latest 12.2(18)SXF16.Everyhing was fine. But when I tried to show module, I found the version of Sup 720 and two ethernet cards became 12.2(18)SXF1 from 12.2(18)SXF3.Is this normal behavior?

I suspect the version (Sup720 is 8.1(3))of hardware did not support the latest version. Is it correct?

If I keep them. did it cause any issues?

Thanks a lot for your help!

2 REPLIES
Hall of Fame Super Bronze

Re: Question of Cat6513 upgrade

The last number is being truncated. It's a normal behavior due to the field length on that column.

The ethernet modules will use whatever IOS is running on the Supervisor, they don't need a separate IOS installation.

HTH,

__

Edison.

New Member

Re: Question of Cat6513 upgrade

thanks for your help!

104
Views
5
Helpful
2
Replies