Question on How to configure VLAN Mapping to GEC links on an ASR 1004
Easy questions regarding ASR1004 and VLAN mapping from How to configure VLAMN mapping to GEC links.
1. Are ip addresses referred under the Port-channel1.xxx the actual ips of the vlan subnets? If not, how exactly is the routing accomplished via parameters in the configuration
2. On the ASR1004 the encapulation parameter under the interface port-channel1.xxx only allows gigabitethernet or fastethernet. It does not allow 10gigabit ethernet. I see option to add multiple vlans on tengigabitethernet. Is there some doc on how to do this as opposed to using the gigabitethernet interfaces as refered to in this writeup.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...