Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Question on passive serial sub interface EIGRP

                   Hi Everyone,

I know how passive interface default works in EIGRP.

I need to confirm below say we have

se0/0/0

no ip address

se0/0/0.10

ip address 192.168.50.1 x.x.x.x

Router eigrp 100

passive interface default

no passive interface se0/0/0

I do not have device to test this so need to confirm if i also need command

no passive interface se0/0/0.10 or not?

Regards

Mahesh

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Question on passive serial sub interface EIGRP

Mahesh

I do not have any device that would allow me to test this either. But I believe that you need to specify the subinterface and not just the physical interface.

HTH

Rick

2 REPLIES
Hall of Fame Super Silver

Question on passive serial sub interface EIGRP

Mahesh

I do not have any device that would allow me to test this either. But I believe that you need to specify the subinterface and not just the physical interface.

HTH

Rick

New Member

Question on passive serial sub interface EIGRP

Hi Rick,

I trust you fully.

Many thanks for confirmation.

Best regards

Mahesh

129
Views
0
Helpful
2
Replies