The Sup2 module in slot 1 failed and slot 2 became active. I replaced the Sup2 module in slot 1. Everything looks Ok and it appears that the CAt OS and IOS images have synched as well. But I don't like the output of the SHOW MODULE command now because it males me feel that the SUP2 modules both are not identical.
WS-X6K-S2U-MSFC2 is the new module in slot 1 that I just put in and it looks identical when I compared with the failed module from slot 1 in terms of components and layout but the failed module in slot 1 front panel says WS-X6K-SUP2-2GE and this is also what the active sup2 in slot 2 also says on the front panel.
The new module - WS-X6K-S2U-MSFC2 which I put in slot 1 initially said version 8.4(1) but after a few minutes of working it said 8.1(1) which is the same as the active module in slot 2.
The MSFC2 versions also became the same - 12.1(19)E1.
Should everything work OK?
My customer is worried that the Sup2 I put in slot 1 doesn't say WS-X6K-SUP2-2GE which is what it used to before this failure happened today.
Also in the config I do not see teh command
SET SYSTEM HIGHAVAILIBILTY/ So how did the Cat OS and IOS on MSFC2 images then synched.
Pleas also point me to any document that explains this clearly. I have looked at dozens of documents and my question is still unanswered.
WS-X6K-S2U-MSFC2 is a Supervisor Engine 2,256 MB of DRAM, dual 1000BASEX Gigabit Interface Converter (GBIC) uplinks, fabric-enabled1, Cisco Express Forwarding (CEF), enhanced quality-of-service (QoS) features, Policy Feature Card 2 (PFC2), and MSFC2. Factory ships with 256 MB on Supervisor 2 and 256 MB of DRAM on MSFC2
I am going to site again. I will get all the information that you have asked. Definetely there is not Set system highavailabilty and Set system highavailabilty versioning enable commands. But do you really need the second command if the customer wants the same versions running on both Sup2. I agree that you need the first command. I will get all the details today. Thanks again.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...