Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

questions about privlidge mode and local users

I am trying to setup a username with a lower level access so they cannot access a config t.

I am having a hard time finding any documentation on what each level does. I only want the user to view a show run. Now i know i could setup a privilage command and then enter in each and eveery command for a show run and set it to lets say level 3 or something.

I dont want to go through all that, i just want to set it to the level where they can view the entire output of a show run.

3 REPLIES

Re: questions about privlidge mode and local users

Hi Donald,

you will need to set first the privlidge for the users , and then assign them the appropriate command.

here what you can do:

1- username xxxx privilidge 2 password yyyy

2- in the config mode;

privlidge level 2 exec (sh run)

like wise, if you need to assign them command in the config mode you will have to type config after the level or if its in the interface you will have to type the interface.

HTH

Mohamed

New Member

Re: questions about privlidge mode and local users

thank you, i realized that. But if i did a level 2 and then set sh run. When they did it, they would not see the entire config. I would also have to set a show ip, sh iterface , sh router ......

so they can see everything in a show run. Isnt there a level i can set that includes all of them?

Hall of Fame Super Bronze

Re: questions about privlidge mode and local users

125
Views
5
Helpful
3
Replies