1. Bootstrap has to load before IOS, and there is no point in having configuration without ios. So it has to be: bootstrap, os, config
2. Transparent mode only PASSESS packets, without interpreting them. Also, only SERVER side changes are recognized by other servers and clients in VTP domain. Client changes are not recognized, and will be overwritten with next update. Transparent side changes are not event sent out, so they stay on the transparent switch. So the answers are d and f.
3. Switch provides microdivision of collision domains, where there is only one collision domain per every switch port. Broadcast domains are controlled by Layer 3. Bandwidth dedication is done using very complex IntServ mechanisms not the switch. Switch does not increase latency much using newest switching methods, and packets pass switch in matters of microseconds. So the answer is D.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...