Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
Blue

Quick BOOT SYSTEM command question

I tried upgrading code on a switch to 12.2(18) SXF7.

I had 12.2(18) SXF7 loaded onto a PCMCIA flash card that was inserted slot 0.

So, I changed the boot system commnads to the following:

boot system flash disk0:s222-adventerprisek9_wan-mz.122-18.SXF7

boot system flash sup-bootflash:c6sup22-jk2sv-mz.121-13.E13

I wanted the 12.2(18) to load first and if it failed to use the old code as a backup.

The switch wouldnt load the new IOS until I added the ".bin" file extension to the boot system command for the 12.2(18) SXF7.

Why?

Why did I not have to do that for the old IOS that was in sup-bootflash and that I left as a backup?

It was a 6500 switch with a SUP 2 module.

1 REPLY
Hall of Fame Super Gold

Re: Quick BOOT SYSTEM command question

Victor

It is basically a function of how Cisco named the images (or how you named the images as you copied them to flash or bootflash). To be sure what name to use in the boot system command use the the appropriate show or dir command to see the content of disk0 or bootflash and verify the image name there.

HTH

Rick

136
Views
0
Helpful
1
Replies
CreatePlease to create content