Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Blue

Quick NAT Question

I dont have a lab right now to lab it up, so I need some expertise...

with the statement

ip nat inside source static network 10.0.0.0 3.0.0.0/24

any address on the 10.0.0.0 network will get NATed to an address on the 3.0.0.0 network, correct?

But how are the 3.0.0.0 address allocated? In numerical order?

Thanks

Victor

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: Quick NAT Question

Victor

In NAT using the static and network combination the host bits of the source address are mapped directly to the bits of the translated address. So if you had address 10.22.33.44 it would be translated into 3.22.33.44.

HTH

Rick

4 REPLIES
Hall of Fame Super Silver

Re: Quick NAT Question

Victor

In NAT using the static and network combination the host bits of the source address are mapped directly to the bits of the translated address. So if you had address 10.22.33.44 it would be translated into 3.22.33.44.

HTH

Rick

Blue

Re: Quick NAT Question

O, OK..

So, its just a one for one then...

So, you would really use this when you want to make a sweeping NAT of an entire network, right?

VL

Hall of Fame Super Silver

Re: Quick NAT Question

Victor

right

HTH

Rick

Blue

Re: Quick NAT Question

OK, thanks, Rick. Appreciate the sanity check.

Have a great night.

Victor

130
Views
5
Helpful
4
Replies