Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

"Current Software state = STANDBY COLD-CONFIG"

Hello,

I've just set-up RPR+. When I enetered the sh redundancy command, I get the following output:

"Current Software state = STANDBY COLD-CONFIG"

Is this something to worry about?

Please advise?

Thanks.

xxxLON#sh redundancy

Redundant System Information:

The only question I have now is regarding this

"Current Software state = STANDBY COLD-CONFIG"

------------------------------

Available system uptime = 1 week, 11 hours, 40 minutes

Switchovers system experienced = 0

Standby failures = 0

Last switchover reason = none

Hardware Mode = Duplex

Configured Redundancy Mode = rpr-plus

Operating Redundancy Mode = rpr-plus

Maintenance Mode = Disabled

Communications = Up

Current Processor Information :

-------------------------------

Active Location = slot 6

Current Software state = ACTIVE

Uptime in current state = 1 week, 11 hours, 37 minutes

Image Version = Cisco IOS Software, RSP Software (RSP-PV-M), Ve

rsion 12.4(10b), RELEASE SOFTWARE (fc3)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2007 by Cisco Systems, Inc.

Compiled Sat 20-Jan-07 01:10 by prod_rel_team

BOOT = disk1:rsp-pv-mz.124-10b.bin,12;

CONFIG_FILE =

BOOTLDR = bootflash:rsp-boot-mz.123-6.bin

Configuration register = 0x102

Peer Processor Information :

----------------------------

Standby Location = slot 7

Current Software state = STANDBY COLD-CONFIG

Uptime in current state = 1 week, 11 hours, 17 minutes

Image Version = Cisco IOS Software, RSP Software (RSP-PV-M), Ve

rsion 12.4(10b), RELEASE SOFTWARE (fc3)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2007 by Cisco Systems, Inc.

Compiled Sat 20-Jan-07 01:10 by prod_rel_team

BOOT = disk1:rsp-pv-mz.124-10b.bin,12;

CONFIG_FILE =

BOOTLDR = bootflash:rsp-boot-mz.123-6.bin

Configuration register = 0x102

xxxLON#

1 REPLY
New Member

Re: "Current Software state = STANDBY COLD-CONFIG"

Hi,I think

It just means that the next supervisor switch over, will take more time.

Please see this link for the whole information:

http://www.cisco.com/en/US/tech/tk869/tk769/technologies_white_paper0900aecd801778e8.shtml

3072
Views
0
Helpful
1
Replies
CreatePlease to create content