Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

" ip load-sharing per-packet " 3750

It seems you cannot enter " ip load-sharing per-packet " on a layer 3 Vlan interface on a 3750. Is this correct and if so, is there a way to configure load sharing on a per packet basis with EIGRP on a 3750?

4 REPLIES
Silver

Re: " ip load-sharing per-packet " 3750

1.To enable per packet load balancing for all IP traffic, enter the ip load-sharing per-packet command in interface configuration mode and enter the epc xpif-ip-per-pack-all global configuration.

2.To enable per packet load balancing for TCP traffic only, enter the ip load-sharing per-packet command in interface configuration mode and ensure the epc xpif-ip-per-pack-all global configuration command is not entered.

Make sure you are running minimum 12.1(10)E

New Member

Re: " ip load-sharing per-packet " 3750

Neither command seems to be a valid command on a 3750 with 12.2(25)SEE2.

Hall of Fame Super Bronze

Re: " ip load-sharing per-packet " 3750

Steve,

You are correct, that command isn't supported in these switches:

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/release/12.2_40_se/configuration/guide/swuncli.html#wp1060469

If you want to load-balance per-packet, you must configure Layer2 or Layer3 etherchanneling.

HTH,

__

Edison.

New Member

Re: " ip load-sharing per-packet " 3750

Thank you.

912
Views
5
Helpful
4
Replies