Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

"ip tcp adjust-mss" on interface Port-Channel

Hi Sir,

I have the following port channel config on a Cisco 7609:

!

interface Port-channel1

ip address 10.10.10.10 255.255.255.0

no ip redirects

no ip unreachables

no ip proxy-arp

ip ospf message-digest-key 1 md5 cisco123

logging event link-status

no mpls ldp igp sync

service-policy input POLICER

service-policy output POLICER

!

interface GigabitEthernet2/1

no ip address

no cdp enable

channel-protocol pagp

channel-group 1 mode desirable

!

interface GigabitEthernet2/6

no ip address

no cdp enable

channel-protocol pagp

channel-group 1 mode desirable

!

Module 2 is a WS-X6724-SFP.

I want to configure the "ip tcp adjust-mss" command on the interface. Please advise whether I should apply the command on the Port-Channel or the physical interfaces or both.

Thank you.

B.Rgds,

Lim TS

3 REPLIES
Hall of Fame Super Silver

Re: "ip tcp adjust-mss" on interface Port-Channel

Hello Lim,

you can configure a command regarding TCP OSI layer4 only on L3 interfaces so member links of the port channel don't need it.

You may need to consider a change on interface mtu and ip mtu.

Also I would consider if the command has to be given on the layer3 interface on the client Vlan.

It is likely that th bundle is a core facing link.

So it may be the wrong place for the command also on the logical interface

Hope to help

Giuseppe

New Member

Re: "ip tcp adjust-mss" on interface Port-Channel

Hi Giuseppe,

Thanks for your reply.

The port-channel interface is facing client.

Thank you.

B.Rgds,

Lim TS

Cisco Employee

Re: "ip tcp adjust-mss" on interface Port-Channel

Hello Lim,

Please allow me a question: Why do you want to use the "ip tcp adjust-mss" command? Do you have a special reason to manipulate the MSS?

Best regards,

Peter

461
Views
0
Helpful
3
Replies