Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

"Monitoring through AUX port"

Hi,

I've a router with LAN address configured on Eth0. I have to attach a system to aux port and have to monitor the aux port when the port is down..I want monitor the port with the ping utility...I want to assign to aux port an IP address, with routing enabled..

How is possible that?

Thank you for your support.

Best regards.

Massimiliano.

4 REPLIES
Hall of Fame Super Silver

Re: "Monitoring through AUX port"

Hello Massimiliano,

I was able to connect two routers in back to back using AUX ports.

see

http://www.cisco.com/en/US/tech/tk801/tk36/technologies_configuration_example09186a0080093c7b.shtml

Hope to help

Giuseppe

Re: "Monitoring through AUX port"

Thank you Giuseppe.

I've already found that configuration example.

Best regards.

Massimiliano.

Hall of Fame Super Silver

Re: "Monitoring through AUX port"

Hello Massimiliano,

the document provides the configuration on the router side.

You need to find the right cable setup to make it working if the other side in your case is a different device.

Hope to help

Giuseppe

Re: "Monitoring through AUX port"

Thank you Giuseppe.

Massimiliano.

148
Views
4
Helpful
4
Replies
CreatePlease to create content