I have an e4506 enclosure with a Sup 8+ card that I simply can not get to report netflow traffic. I am using the Solarwinds NetFlow Realtime analyzer. My switch configurations are as follows:
flow record RECORD1
match ipv4 tos
match ipv4 protocol
match ipv4 source address
match ipv4 destination address
match transport source-port
match transport destination-port
collect interface input
collect interface output
collect counter bytes
collect counter packets
!
!
flow exporter EXPORT1
destination 10.10.3.104
source Vlan10
transport udp 2055
!
!
flow monitor MONITOR1
exporter EXPORT1
cache timeout active 300
record RECORD1
!
!
!
output omitted
!
!
!
vlan configuration 10
ip flow monitor MONITOR1 input
vlan internal allocation policy ascending
When I look in the analyzer, there is nothing in the "Flow type" field for vlan10. ALSO, whenever I run the "show flow interfaces" command, nothing comes up. Its like it isn't actually being applied to vlan 10.
Somehow, my previous thread got marked as "answered" however, I never did get a correct answer. I have read many different forums where people were having very similar issues w/ the Solarwinds analyzer and Netflow. Does anyone have any suggestions?